Adjust Cutting Height - Husqvarna AUTOMOWER 440 Operator's Manual

WARNING: Only charge the robotic lawnmower
using a charging station which is intended for it.
Incorrect use may result in electric shock,
overheating or leakage of corrosive liquid from
the battery.
In the event of leakage of electrolyte flush with
water and seek medical help if it comes in
contact with the eyes etc.
1. Set the main switch to position
2. Place the robotic lawnmower in the charging station.
Open the hatch and slide the robotic lawnmower in
as far as possible to ensure proper contact between
the robotic lawnmower and the charging station. See
contact and charging strips in
page 6
3. The display shows a message that charging is in
progress.

4.9 Adjust cutting height

The cutting height can be varied from
MAX (6 cm / 2.4 in.) in nine stages.
in.) to
During the first week after a new installation, the cutting
MAX to avoid damaging the loop
height must be set to
wire. After this, the cutting height can be lowered one
step every week until the desired cutting height has
been reached.
If the grass is long, let the robotic lawnmower to start
MAX cutting height. Once the grass is
mowing at the
shorter, you can gradually lower the cutting height.
4.9.1 To adjust the cutting height
CAUTION: During the first week after a new
installation, the cutting height must be set to
MAX to avoid damaging the loop wire. After this,
the cutting height can be lowered one step
every week until the desired cutting height has
been reached.
1. Press the STOP button to stop the robotic
lawnmower and open the hatch.
2. Press the MENU button to access the main menu.
3. Move the cursor using the arrow keys to select
Cutting height .
a) Press the up arrow key to increase the cutting
height.
b) Press the down arrow key to lower the cutting
height.
4. Press OK.
46 - Operation
1 .
Product overview on
MIN (2 cm / 0.8
447 - 001 -