Husqvarna AUTOMOWER 440 Operator's Manual page 36

Place the mower centrally in your yard. Select
Accessories > Automower Connect (robotic lawnmower
GeoFence . Activate the function by
PIN required) >
Activate GeoFence and pressing OK. Select
selecting
New center point to set the origin for GeoFence.
GeoFence sensitivity can be changed to suit your yard.
Low , Medium or High . The
Sensitivity can be set to
higher the sensitivity, the easier the alarm is activated. If
the alarm is activated too easily, you should select a
lower setting for the GeoFence sensitivity.
When putting the robotic lawnmower into storage for a
long period, such as during the winter, we recommend
turning off the main switch. With the GeoFence function
activated, you will need the PIN code in order to turn off
the robotic lawnmower. Once the main switch has been
turned off, the Connect function will stay active for
another 12 hours. After that it will not be possible to
communicate with the robotic lawnmower and the
GeoFence function will not be active.
3.19.2.7 Communication
Communication
Use SMS
The SMS function must be activated from the mower
menu before it can be used. Select
Automower Connect (robotic lawnmower PIN required)
Communication > Use SMS .
>
SMS phone numbers
The telephone numbers to the mobiles allowed to
communicate via SMS must be entered into the list of
SMS numbers. The numbers must be entered with their
country codes, e.g. (+)46701234567. Use the Test-SMS
function to verify the specified telephone number. A text
will then be sent to all the telephone numbers on the list.
The list can have up to three numbers.
With the SMS function activated, an SMS will be sent to
all the telephone number in the list if the mower is found
outside the GeoFence. Certain information can also be
retrieved from the robotic lawnmower by sending it an
SMS. An SMS with the command "GET GPS INFO" to
the mower will give information concerning its position,
the origin of GeoFence and its radius together with the
GPS signal strength. Note that the telephone of the
sender must be specified in the robotic lawnmower. A
maximum of 10 SMS per month can be sent from the
mower.
3.19.2.8 Network
Network SIM PIN
APN settings
SIM PIN
This menu is only applicable if you use a non-Husqvarna
SIM.
36 - Installation
Use SMS
SMS phone
numbers
Accessories >
APN settings
The robotic lawnmower must specify APN settings to be
able to use and send data via the mobile net. Settings
for Husqvarna SIM is default.
3.19.2.9 Reset
If you choose the function
confirm that you want to
Automower Connect settings.
3.19.3 Headlights
The headlights are applicable for Automower 430X and
Automower 450X.
Settings concerning the headlights are made using this
function. The headlights are included for Automower
450X and available as accessory for Automower 430X.
3.19.3.1 Schedule
Select when to turn on the headlights in the Schedule
sub-menu.Choose between Always ON, Evening only,
Evening & night or Always OFF.
The headlights are turned on/off for the various schedule
alternatives on the following occasions:
On
Evenings only At sunset
Evenings and At sunset
nights
3.19.3.2 Flashes when fault
Flashes when fault is activated the headlights will flash
If
if the robotic lawnmower has come to a standstill
because of a fault.
3.19.4 Ultrasonic
Ultrasonic is applicable for Automower 450X. It ensures
that the mower reduces speed before it hits an obstacle.
This function can be turned off, which means the mower
will always operate at a lower speed.
3.19.5 Mower house
This function handles the settings for the mower house.
Mower house
3.19.5.1 Avoid collisions with mower house
If this option is selected, the wear on the mower and the
house is reduced, but it can result in more uncut grass
around the charging station.
Reset you will then need to
Proceed with reset of
Off
Midnight
At sunrise
Avoid collision with
mower
447 - 001 -