Aaeon SBC-555 Manual page 51

Resource Controlled by
The Award Plug and Play BIOS has the capacity to automatically
configure all of the boot and Plug and Play compatible devices.
However, this capability means absolutely nothing unless you are
® .
using a Plug and Play operating system such as Windows 95
Reset Configuration data
This item allows you to determine reset the configuration data or
not.
IRQ3/4/5/7/9/10/11/12/14/15, DMA0/1/3/5/6/7 assigned to
This item allows you to determine the IRQ/DMA assigned to the
ISA bus and is not available to any PCI slot.
PCI IRQ Activated By
This sets the method by which the PCI bus recognizes that an IRQ
service is being requested by a device. Under all circumstances,
you should retain the default configuration unless advised other-
wise by your system manufacturer.
Choices are Level and Edge.
PCI IDE IRQ Map To
This allows you to configure your system to the type of IDE disk
controller in use. The more apparent difference is the type of slot
being used.
If you have equipped your system with a PCI controller, changing
this allows you to specify which slot has the controller and which
PCI interrupt (A, B, C or D) is associated with the connected hard
drives.
Remember that this setting refers to the hard disk drive itself,
rather than individual partitions. Since each IDE controller
supports two separate hard drives, you can select the INT# for
each. Again, you will note that the primary has a lower interrupt
than the secondary.
Selecting PCI Auto allows the system to automatically determine
how your IDE disk system is configured.
Primary IDE INT#
Refer to the abve description of PCI IDE IRQ.