Triax 492055 User Manual page 27

Rev. 01 - 2012 - C
A barker channel carries all EIT information for a number of services.
Using a barker channel all EIT information will be transferred from the indi-
vidual outputs to the barker channel thereby making more room/ payload
available to the output of services.
Note
If you to use a barker channel to carry the EIT information you have
to make sure that the set-top boxes used by end-users are NorDig
compliant, i.e. they can read a Linkage Descriptor from a NIT.
Enable barker
channel for DVB-T/
DVB-C
Unit
Backend
Output
In the service list area you determine the numerical output order of the digital
services on the television or set-top box of the end-user.
LCN number
When you have entered the values you require you have to click the Submit
button to enter this information into the headend system.
TDX Service Tool
Click the this check box to enable a barker channel for
DVB-T and/or DVB-C .
Enter the ID number of the unit you where you want to
place the barker channel. You can enter values 1-3.
"1" = main unit
"2" = unit 1
"3" = unit 2
Enter the number of the output module where you want
to place the barker channel. You can enter values 1-6
Enter the number of the output where you want to
place the barker channel. You can enter values 1-4.
Enter the desired number in the LCN number field to
the right of each service in the service list area.
Note
You cannot give the same LCN number to
more services.
27