Troubleshooting; Special Accessories; Exploded Drawing And Spare Parts List - Mafell Z5Ec Original Operating Instructions

7

Troubleshooting

Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,
contact your dealer or the MAFELL customer service.
Defect
Machine cannot be switched on
Undervoltage shutdown
Saw band is stuck
Chip ejection blocked
8

Special accessories

- Pair of adapters for parallel stop for hooking into the guide rail
- Guide rail cpl., 3 m (9.8 ft) long
- Guide rail extension part, 1.5 m (4.9 ft) lang
- Guide rail one-piece, cpl., 3 m (9.8 ft) long
- Transport cart Z 5 Ec
- Saw bands, 10 pcs 1752 x 6 x 0.65 4 teeth/1"
- Saw bands, 10 pcs 1752 x 6 x 0.65 6 teeth/1" fine
- Saw bands, 10 pcs 1752 x 8 x 0.65 4 teeth/1"
- Saw bands, 10 pcs with serration 1752 x 8 x 0.65 4 teeth/1"
9

Exploded drawing and spare parts list

The corresponding information in respect of spare parts can be found on our homepage: www.mafell.com
Danger
Determining the causes for existing defects and eliminating these always
requires increased attention and caution. Unplug the rechargeable battery
beforehand!
Cause
No mains voltage
No mains voltage (power
interruption)
Dull saw band
Wood is too damp
Extended operation without
extraction
-20-
Elimination
Check power supply
Switch machine off and on again
Replace saw band
Connect to an external extraction,
e.g. portable dust extractor
Order No. 037195
Order No. 037037
Order No. 036553
Order No. 200672
Order No. 202110
Order No. 092335
Order No. 092333
Order No. 092336
Order No. 092337