Service And Maintenance; Storage; Troubleshooting - Mafell MT55cc Operating/Safety Instructions Manual

MT55cc
5.10.4 Working with the diamond saw blade in fiber cement boards
The diamond saw blade was developed for fiber cement boards. The teeth fitted with
diamonds are more fragile than the teeth of a carbide saw blade. Therefore, use a guide
rail for work. (see chapter 5.10.1 Working with the guide rail)
6

Service and maintenance

MAFELL machines are of a low-maintenance design.
The installed ball bearings are lubricated for life. After a longer period of operation, MAFELL recommends that
the machine be handed over to an authorized MAFELL service workshop for inspection.

6.1 Storage

Clean the machine thoroughly if you will not use it for quite some time. Spray bare metal parts with a rust
inhibitor.
7

Troubleshooting

Some of the most common malfunctions and their causes are listed below. For other malfunctions, please
contact your dealer or MAFELL Customer Service directly.
Malfunction
Machine can not be switched on
Machine stops during the cutting
process
01/2022
Warning
Risk of injury from a sudden start of the machine.
There is a risk that the machine starts suddenly due to carelessness when
working with the machine or during troubleshooting. The rotating saw blade can
cause serious injuries.
Determining the causes of existing malfunctions and their elimination
➢
always require increased attention and caution!
➢ Pull out the mains plug before you start troubleshooting!
Cause
Mains voltage missing or too low
Mains fuse defective
Carbon brushes worn out
Mains failure
Machine overload
Carbon brushes worn out
Elimination
Have the power supply checked
by an electrician
Have fuse replaced by an
electrician
Take the machine to the MAFELL
customer service workshop
Have the mains back-up fuses
checked by an electrician
Reduce feed rate
Take the machine to the MAFELL
customer service workshop
27