Storage; Service And Maintenance; Machine Care; Troubleshooting - Mafell PSS 3100 SE Original Operating Instructions And Spare Parts List

- Take off the extension if it has been installed.
- Detach the two hexagon socket head cap screws
36 with the Allen key 3.
- Move the bracket handle 35 in the guide rail
groove until marking 37 is located in the centre of
the bracket handle.
- Retighten the hexagon socket head cap screws 36
and return the Allen key to its retaining bracket on
the motor casing.
- Once the bracket handle has been set like this, an
ergonomically favourable transport of the machine
as shown in Fig. 12 is possible.

6.2 Storage

For space-saving storage it is recommended to lean
the board sawing system vertically against the wall
with the saw unit in home position. The standing edge
on the operator panel is equipped with an antislip
coating.
Before this storage, always remove
the extension, thus preventing the
rails from bending.
7

Service and maintenance

If the machine is not used for a longer period of time,
it has to be carefully cleaned. Spray bright metal parts
with a rust inhibitor.
8

Troubleshooting

Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,
contact your dealer or the MAFELL customer service.
Defect
Saw blade drive cannot be
switched on
Danger
Determining the causes for existing defects and eliminating these always
requires increased attention and caution. Pull the mains plug beforehand!
Cause
No mains voltage
Mains fuse defective
Carbon brushes worn
-31-

7.1 Machine care

Danger
Pull the power plug during all
service work.
MAFELL machines are designed to be low in
maintenance.
The ball bearings used are greased for life. When the
machine has been in operation for a longer period of
time, we recommend to hand the machine in at an
authorised MAFELL customer service shop for
inspection.
Only use our special grease, order No. 049040 (1 kg
tin) for all greasing points.
7.2 Storage
The machine must be regularly cleaned of deposited
dust (daily when processing gypsum fibre board). At
the same time, joints and guide pieces in particular in
the guide rail as well as the ventilation openings on
the motor should be cleaned with a vacuum cleaner.
Occasional spraying with machine oil maintains the
ease of movement of joints and guide pieces.
Disposal
Check power supply
Replace fuse
Take the machine to a MAFELL
customer service shop