Working With The Guiding Device; Service And Maintenance; Storage; Troubleshooting - Mafell KSS300 Operating/Safety Instructions Manual

Use the following procedure to adjust the cutting
width:
1. Loosen the wing screws (5) on each side.
2. Adjust the parallel guide fence.
3. Tighten the wing screws (5) on each side.
The cutting width is adjusted.
✓
In addition, the parallel guide fence can also be used as a double support for a better
guidance of the hand-held circular saw. Simply turn it over (the guide tab (22) points
upwards).
Alternatively, you can guide the machine with the parallel guide fence along a guide rail or a
wooden ledge fixed on the workpiece. This requires the parallel guide fence to be rotated so
that the guide tab (22) points upwards.

5.11 Working with the guiding device

The description for the guiding device can be found in the enclosed instructions "Guiding
device L/M/ML/S".
6

Service and maintenance

MAFELL machines are of a low-maintenance design.
The installed ball bearings are lubricated for life. After a longer period of operation, MAFELL recommends that
the machine be handed over to an authorized MAFELL service workshop for inspection.

6.1 Storage

Clean the machine thoroughly if you will not use it for quite some time. Spray bare metal parts with a rust
inhibitor.
7

Troubleshooting

26
Warning
Risk of injury from a sudden start of the machine.
There is a risk that the machine starts suddenly due to carelessness when
working with the machine or during troubleshooting. The rotating saw blade can
cause serious injuries.
Determining the causes of existing malfunctions and their elimination
➢
always require increased attention and caution!
Pull out the mains plug before you start troubleshooting!
➢
Fig. 21: Adjusting the cutting width via the parallel guide
fence
KSS300
01/2022