Startsequence/Endsequence - W&T Com-Server++ Manual

W&T
10�1�1 Startsequence/Endsequence
The Com-Server sends the datagram when one of the two
configured Start AND End sequences has been received. If the
network send will be triggered only by an End Sequence, Start
Sequence Size 1 and Start Sequence Size 2 must be configured
to 0.
n Activate this Packet Option (Telnet)
Activates the selected option for serial data reception.
n Start Sequence Size 1/2
Enter the length of the respective Start Sequence in bytes.
The max. length is 3. A value of 0 deactivates monitoring
of the Start Sequence.
n Start Sequence 1/2
Hexadecimal, space-delimited byte sequence of the re-
spective Start Sequence. The input field is only activated if
the sequence size was previously specified and sent to the
Com-Server.
n End Sequence Size 1/2
Enter the length of the End Sequence in bytes. The max.
Length is 3.
n End Sequence 1/2
Hexadecimal, space-delimited byte sequence of the re-
spective End Sequence. The input field is only activated if
the sequence size was previously specified and sent to the
Com-Server.
n Additional Bytes
Number of bytes which follow after the End Sequence 1 or
2 and belonging to the serial datagram (e.g. checksum)
Subject to error and alteration
Packetizing serial datagrams
81