Configuring The Slip Mode - W&T Com-Server++ Manual

W&T
21�1�1 Configuring the SLIP mode
1 You may not configure for SLIP routing in the same
Telnet session in which the IP address, the subnet mask
or the gateway address for the Com-Server was already
changed. After you make such serttings you must first close
the Telnet connection using q and then reopen
SETUP Port x
...
TCP/IP Mode
n Net Address
Enter here the network address of the serially connected
subnet you want to route to via SLIP.
n SLIP-Net Routing
Default: active
If this parameter has a value of 1, the Com-Server func-
tions as described like a router for the subnet specified
under Net Address. If the parameter is 0, the Com-Server
is transparent, i.e. all packets directed to the IP address
of the Com-Server are forwarded as SLIP packets to the
serial port. The destination IP address (IP address of the
Com-Server) is replaced by the parameter Net Address.
This allows you to assign individual IP addresses to the
connected SLIP computers (=Net Address) without having
to assign a separate subnet for each connection.
1 Excluded from this procedure are packets for the
Telnet configuration port 1111 of the Com-Server!
Subject to error and alteration
...
SLIP Router
Net Address
SLIP Net Routing
Mode SLIP router
167