W&T Com-Server++ Manual page 161

W&T
Opening the Telnet connection
After saving the connection data the Com-Server waits to re-
ceive any serial character. This is the trigger for opening the
connection.
Closing the Telnet connection
To close the Telnet connection, use the following methods
available in the Submenu ...Telnet Client r Special Options.
n Special Options r Inactivity Timeout
Default: 30s
Here you can specify the value for a timer. When the
specified time expires, the Com-Server port closes the
connection. The timer is reset if there is an active network
connection when data are being exchanged. If no data are
set within the specified time, the Com-Server port closes
the connection to the TCP server. InactivityTimeout = 0
deactivates the connection closing after a timeout.
Format: decimal
n Special Options r Disconnect Char
Default: 0
When the Com-Server port receives the character confi-
gured here at its serial port, the Com-Server port closes
the connection to the Telnet server. It is important that
this value not be used within a Telnet session, since this
would result in premature closing. The character itself is
not sent. The factory set value is 0. Disconnect Char = 0
deactivates this mode
Format: decimal
Subject to error and alteration
Mode Telnet Client
161