Optional Settings - W&T Com-Server++ Manual

W&T
13�1�4 Optional settings
The following optional settings allow you to activate and
deactivate various special functions. These apply to fixed as
well as serial addressing.
Special Options r Write „C"+Addr (Default: deactive)
SETUP Port x
...
TCP/IP Mode
Set this switch to active (1) to output the sender address in
ASCII format before outputting the data for a UDP datagram
to the serial port. The string always contains 22 characters.
C IP-Addresse, Portnummer (z.B. „C172.016.231.101,04800")
Serial transmission parameters
SETUP Port x
...
UART Setup
Baud rate, data bits, parity and handshake procedure must
conform to the connected serial device. For details see section
Configuration of the Serial Port.
Packeting options for serial receive data
SETUP Port x
...
TCP/IP Mode
Subject to error and alteration
...
UDP Client
Special Options
Baud, Parity, Data Bits,
Stopbits, Handshake
UDP Client
Special Options
System Options
Packet Options
Mode UDP peer
Write: "C"+Addr
Activ. Packet Options
115