Deactivating Udp Mode - W&T Com-Server++ Manual

W&T
Mode UDP peer
When sending serial protocols such as Modbus/RTU, it is of-
ten necessary to send serial received datagrams also closed
on the network side in a TCP packet. The menu paths shown
above offer various ways to parameterize serial packet limits
(pause times, start-/end sequences, datagram lengths) and to
activate their processing for the respective mode. Details can
be found in the section Packeting of serial datagrams.
13�1�5 Deactivating UDP mode
Set the following parameters in the menu branch SETUP Port
x r TCP/IP Mode r UDP Client to a value of 0 and save this
change:
... r Server Port
... r Special Options r Client: „C"+Addr
Alternately you may use the function SETUP Port x r Port Sta-
te r Clear Port Mode. The Connection State in the Submenu
SETUP Port x r Port State must then be named FREE.
116