W&T Com-Server++ Manual page 146

W&T
18�1�2 The automatic FTP client mode
This mode is recommended whenever you need to execute
the same command over and over again. The FTP commands
are configured in the Com-Server. The latter opens a con-
nection to the FTP server when it receives data at the serial
port. It sends the login and runs the configured file command
(getting serial data and saving as a file or reading a file from
the FTP server and outputting at the serial port). Closing the
FTP session and TCP connection is time-based or optionally by
using a reserved character (Protocol Char).
Activation and configuration
SETUP Port x
...
TCP/IP Mode
n Auto FTP
Set this switch to active to activate the automatic FTP cli-
ent.
n FTP Client Login
Enter the FTP commands one after the other. If a com-
mand sequence is already configured, it is displayed when
opening the menu and can be overwritten.
n Login
Login name for the FTP server
n Password
Login password for the FTP server
n [TYPE A/TYPE I]
Transmission mode (ASCII/binary). The complete string
TYPE A or TYPE I in all caps.
146
FTP Client
Special Options
Mode FTP client
Auto FTP
FTP Client Login