Factory Defauls Settings - W&T Com-Server++ Manual

W&T
1�3

Factory defauls settings

The list contains an overview of the most important settings.
For many applications, such as the W&T COM Port Redirector,
no additional configurations need to be made besides assig-
ning the network base parameters. Detailed information on
the respective parameters can be found in later sections of
this manual.
Network settings
Hardware connection:
IP address:
Gateway address:
Subnet mask:
DHCP:
1 To prevent unintended address assignments or
changes, we recommend deactivating the DHCP protocol
if it is not expressly used in the respective network environ-
ment.
Serial settings
Hardware connection:
Baud rate:
Data bits:
Parity:
Stop bits:
Handshake:
Fifo:
Configuration access
Per Telnet using TCP port 1111
Network applications / Operating mode
(suitable for use with W&T COM redirector)
TCP server ports, port no. A-C:
Control port TCP, port no. A-C:
12
Auto negotiating
0.0.0.0
0.0.0.0
255.0.0.0
Active
RS232
9600
8
NO
1
None
OFF
8000, 8100, 8200
9094, 9194, 9294