The Following Fault Message Appears In The Display And The Program Has Been Canceled - Miele WWH 860 Operating And Installation Instructions

Frequently Asked Questions
The following fault message appears in the display and the
program has been canceled
Message

Water intake See


Drainage See 

 Service
Waterproof syst. 

 Service Fault F
To switch off the fault indicator: Turn the program selector to the  position and
switch the washing machine off.
60
Possible cause and solution
The water inlet is blocked or restricted.
 Check whether the faucet is turned on properly.
 Check whether the inlet hose is kinked.
 Check whether there is sufficient water pressure.
The filter in the water inlet is blocked.
 Clean the filter.
The drain is blocked or restricted.
The drain hose has been fixed too high.
 Clean the filter and the pump.
 The maximum drain height is 39" (1 m).
The water protection system has activated.
 Close the faucet.
 Contact the Service department.
There is a fault.
 Disconnect the washing machine from the
electricity supply, either by withdrawing the plug
from the socket or by disconnecting it at the fuse.
 Wait at least 2 minutes before reconnecting the
washing machine to the electricity supply.
 Then switch the washing machine on again.
 Restart the program.
If the fault message appears again, contact the
Service department.