Connect On Dvip Interface - Datavideo SE-500MU Instruction Manual

After successfully installing the SE-500MU's Software Control UI, follow the connection setup
procedures outlined in the next two sections to establish direct connection between your PC and the
switcher.

2.3.2 Connect on DVIP Interface

To connect to the SE-500MU on the DVIP interface, you should configure the network settings of the
switcher as well as the PC.
1. Connect one end of the Ethernet cable to SE-500MU and another end to the PC.
2. Turn ON the PC power and since the SE-500MU has a default IP of 192.168.100.101, we have set
the PC's IP address to 192.168.100.102 as shown in the diagram below.
11