7.3.4 Check
When units have been connected or disconnected since last detecting the
topology you can check for any changes to the topology.
To do so:
1.
Click
connected but undefined
2.
To define the units connected to the ports, click the checkbox of
a port or a number of ports that have the same device connected.
3.
Click
4.
Select the device type.
When the device is a Line Splitter, repeat the process of defining the connected devices
for each port of the Line Splitter.
Check does not update the topology, it detects any new connections and units that are
disconnected appear with a yellow exclamation mark
Update
To add new devices to the present topology click
devices appear. Units that are disconnected appear with a yellow
exclamation mark
7.3.5 Manual
You can display the topology manually whether the system is online or
offline.
To display the topology manually:
1.
Click
2.
Select the connected Transmitter. The selected topology appears
on the left, see Figure 19. If the Service Utility is online you can
CHAPTER 7: HD View system management
. Any new units detected appear as an
. You must still define the unit.
. A drop-down menu appears.
Note!
Note!
.
. A drop-down menu appears.
.
. The new
25