Table of Contents
Advertisement
HD VIEW
Sending/blocking a Serial command
Click
to toggle between sending and blocking a Serial command.
When sending a Serial command the device icons appear with an arrow
like this:
.
Sending/blocking a bi-directional Serial command
When sending a Serial command, you can send a bi-directional Serial
command to a single Receiver / Receiver - LR.
Click
to send the bi-directional Serial command. The device icon
appears with a double arrow like this:
. Click again to block the bi-
directional Serial command. You can then send the bi-directional Serial
command to a different Receiver / Receiver - LR.
7.5 Tuning Receivers - LR (or Line Splitters) via the Service
Utility
You can tune the Receivers - LR / Line Splitters with the Service Utility
from the Transmitter position or from the Receiver - LR / Line Splitter
itself. The advantage of tuning from the Receiver - LR, is that you can see
the tuning on the screen as you perform it. From the Line Splitter
position you can be closer to the screen than from the Transmitter
position.
To tune from the Transmitter position:
Connect the Serial Download cable to the Control port of the Transmitter
and the Serial port of a computer which has the Service Utility installed.
To tune from the Receiver - LR or Line Splitter position:
Connect the Serial Download cable to the Receiver - LR or Line Splitter
Tuning port and the Serial port of a computer containing the Service
Utility. See the figure below.
30
30
Advertisement
Table of Contents
