Microscan Visionscape CMGC03 Manual page 70

Chapter 2
System Components
Check the Use persistent IP box and uncheck the Use DHCP box. Enter
192.168.254.3 in the lower IP address box and 255.255.255.0 for the
Subnet mask. Click Apply. You will be prompted to reboot the camera as
follows:
Cycle power to the camera and you are ready. The config tool will now
show the following:
Now, every time the camera is rebooted it will automatically set this IP
address so it will not have to search the network to determine what IP
address to use.
This is ideal in fixed industrial setups. However, it does mean that you
cannot simply swap cameras from NIC to NIC or even change the
address of the NIC without having to reconfigure the camera address.
2-60 Visionscape GigE Camera Guide v4.1, November 2011