Table of Contents
Advertisement
Table 5.22: Show Command Summary (Continued)
Command
Show Server SNMP
Show User
Show Port command
The Show Port command displays configuration and status information about one or all ports.
Access right: SMON
Access level: ADMIN or APPLIANCEADMIN
Syntax
SHOW PORT [<port>|ALL|NAMES]
The SHOW PORT NAMES command display includes the port numbers and names. If a port has
not been given a name with a Port Set command, the default name is displayed. A default name
contains the last three octets of the MAC address plus the port number.
Table 5.23: Show Port Command Parameter
Parameter
<port>
ALL
NAMES
Table 5.24 lists the display fields for a Show Port command that specifies one or all ports.
Table 5.24: Show Port Command Display Fields
Field
Port
Serial Port Settings
TX Bytes
RX Bytes
Errors
Description
Displays SNMP configuration information.
Displays user configuration and session information.
Description
Either a port number in the range 1-48 or CON.
Default = your port
Displays information about all ports.
Displays port numbers and associated logical names.
Content
Port number.
Comma-separated string of port values: baud rate, number of bits, parity, stop bits,
flow control, socket number, time-out value and CLI access character (from Port Set
command). The CLI character is preceded by POR CLI= if it was defined with a Port
Set command or by SER CLI= if it was defined with a Server CLI command.
Number of bytes transmitted.
Number of bytes received.
Number of TX/RX parity and framing errors.
Chapter 5: CCM Appliance Commands
59
Advertisement
Table of Contents
