Server Snmp Trap Destination Command; Server Ssh Command - Equinox Systems Equinox Console Manager CCM4850 CCM4850 CCM4850 Installer/User Manual

Syntax
SERVER SNMP TRAP [ENABLE|DISABLE] [ALL]
Table 5.19: Server SNMP Trap Command Parameter
Parameter
ENABLE|DISABLE
Example
The following command enables the linkUp, userDeleted and userLogin SNMP traps.
server snmp trap enable
Traps now disabled:
1) linkUp
2) userAdded
3) userDeleted
Select trap(s) to enable>1,3-4

Server SNMP Trap Destination command

The Server SNMP Trap Destination command defines or deletes destinations for enabled SNMP
traps. Once you define destinations for enabled SNMP traps, when a trap occurs, the CCM
appliance will generate SNMP trap messages to each defined SNMP trap destination. You may
define up to four trap destinations, using separate commands.
For more information, see Managing the CCM Appliance Using SNMP on page 28.
Access right: SCON
Access level: APPLIANCEADMIN
Syntax
SERVER SNMP TRAP DESTINATION ADD|DELETE <ip_address>
Table 5.20: Server SNMP Trap Destination Command Parameters
Parameter
ADD|DELETE
<ip_address>

Server SSH command

The Server SSH command enables or disables SSH session access to the CCM appliance and
specifies the SSH authentication method. When you enable SSH, all CCM sessions will be
Description
Enable generates a numbered list of currently disabled traps from which you choose
those to enable. Disable generates a numbered list of currently enabled traps from
which you choose those to disable.
4) userLogin
5) imageUpgradeStarted
Description
Defines or deletes the specified destination.
IP address of trap destination.
Chapter 5: CCM Appliance Commands 57