Table of Contents
Advertisement
Table 5.9: Server Command Summary (Continued)
Command
Server SNMP Trap
Server SNMP Trap
Destination
Server SSH
Server CLI command
The Server CLI command:
•
Specifies the console port type
•
Specifies the CLI access character
•
Enables or disables device connection from the console port
•
Specifies a modem initialization string
•
Specifies port history mode operations
•
Specifies a port time-out value
At least one parameter must be specified.
Access right: SCON
Access level: APPLIANCEADMIN
Syntax
SERVER CLI [TYPE=<type>] [CHAR=^<char>] [CONNECT=ON|OFF]
[HISTORY=HOLD|AUTO,CLEAR|KEEP] [MODEMINIT="<string>"]
[TIMEOUT=<time-out>]
Table 5.10: Server CLI Command Parameters
Parameter
TYPE=<type>
CHAR=^<char>
Description
Enables/disables SNMP traps.
Defines/deletes destinations for enabled SNMP traps.
Enables/disables SSH session access to the CCM appliance and specifies the
SSH authentication method.
Description
Terminal type to be used on the console port. The entire name of the type must
be specified; abbreviations are not permitted. Valid types are: ASCII, VT52,
VT100, VT102, VT220 and VT320.
Default: ASCII
CLI access character in the range A through _ (underscore). (The allowable
ASCII range is 0x41-0x5F and 0x61-0x7A.) The CLI access character, when
pressed simultaneously with the
serial device, will suspend the session with the device and place you in CLI
command mode. This value will be used if a port's Port Set command contains a
Char=None parameter.
Default = ^d
Chapter 5: CCM Appliance Commands
Ctrl
key during a session with an attached
49
Advertisement
Table of Contents
