Remote Access Configuration Sub-Menu - Psion Teklogix Vehicle-Mount Computer 8590 User Manual

E.5.10 Remote Access Configuration Sub-Menu
Feature
Remote Access
Serial Port
Number
Serial Port Mode
Flow Control
Redirection After
BIOS POST
Terminal Type
Options
Enable/Disable the BIOS remote access feature.
Note: If the systems serial ports are disabled in
Disabled
the 'I/O Interface configuration' submenu, then
Enabled
serial redirection is disabled and 'Remote access
configuration' menu is unavailable to the users.
Select the serial port you want to use for console
COM1 redirection.
COM2 Note: Only enabled serial ports are presented as
an option.
Select the baud rate (transmitted bits per second)
you want the serial port to use for console redi-
115200 8,n,1
rection.
57600 8,n,1
Note: The terminal program used with serial
19200 8,n,1
redirection must be set to use exact the same set
of communication parameters.
None
Hardware Select the flow control for serial redirection.
Software
With Disabled, serial redirection functionality is
disabled at the end of BIOS POST.
If set to Always, all resources and interrupts
associated with serial redirection are protected.
Disabled This option lets serial redirection permanently
Boot Loader reside at base memory which allows the console
Always to be redirected.
If set to Boot loader, serial redirection is active
during the OS boot loader process. This allows
boot status messages to be redirected, but serial
redirection will terminate when the OS loads.
Select the target terminal type.
ANSI
Escape sequences representing keystrokes are
VT100
sent to the remote terminal based on these set-
VT-UTF8
tings.
8580/8590 Vehicle-Mount Computer User Manual E-15

Remote Access Configuration Sub-Menu

Description
Appendix E: BIOS