Test Platform Self-Leveling; Test Emergency Power - Skyjack SJ46AJ Operating Manual

Function Tests
Base Control Console
•

Test Platform Self-leveling

1. Lower boom to stowed position.
2. Adjust platform to a level position using
platform leveling switch.
3. Raise "
boom through a full cycle.
Result: Platform should remain level at all
time.
•

Test Emergency Power

1. On base control console, push in "
emergency stop button to turn engine off.
2. On platform control console, push in "
emergency stop button.
When operating on auxiliary power, do
not operate more than one function
at a time to avoid overloading 12-Volt
auxiliary pump motor. Do not use
emergency power unit continuously for
more than two minutes.
To conserve battery power, test each
function through a partial cycle.
Page 30
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
Off/Base/Platform
Key Switch
Emergency
Stop
Start/Function
Enable/
Emergency
Power Switch
" and lower " " main
"
"
CAUTION
NOTE
December 2007
contained in this operating manual and on the aerial platform.
Section 2 - Familiarization
Base/Off/Platform
Key Switch
3. On base control console, pull out "
emergency stop button.
4. O n b a s e c o n t r o l c o n s o l e , t u r n
off/base/platform (base/off/platform) key
switch to " " platform position.
5. Select " " emergency power
position from start/function enable/
emergency power switch and activate
each boom function.
Result: All selected functions should
operate.
6. Turn off/base/platform (base/off/platform)
key switch to " " base position.
7. Select " " emergency power
position from start/function enable/
emergency power switch and activate
each boom function.
Result: All selected functions should
operate.
NOTE
The emergency power
two-minute duty cycle.
Emergency
Stop
"
unit has
SJ 46AJ