Accessories - Nortec EL005 Installation Manual

Remote blower pack power
kit
4.5

Accessories

Table 3
shows the list of accessories for the Nortec EL steam humidifier. Contact your Nortec representative
for details. To install and operate the accessories, refer to the instructions supplied with the accessories.
Table 3: Nortec EL Accessories
Accessory
Steam distributor
SAM-e steam distribution
manifold
Blower pack, built-on or
remote
Digital or analog control
humidistat with either On/Off
or modulating operation
Digital RH transducer
Digital or analog high limit
humidistat with either On/Off
or modulating operation
Air proving switch
Outdoor temperature sensor
Product Overview
10
Option
When a remote blower pack is being installed with the humidifier, this option provides a
transformer, fusing, and a terminal block inside the humidifier to provide power to the remote
blower pack. Without this option, a separate 110-120V supply must be provided for the
remote blower pack.
Steam distribution system for use in an air duct.
Steam distribution system for use in an air duct where reduced absorption distance is re-
quired.
For direct room humidification or use in conditioned spaces without a built-in air distribution
system. The EL Space model has a blower pack mounted directly, the EL RMBP model has
power for a remote-mounted blower pack (blower pack ordered as an accessory).
Input device used to meter the output of the humidifier based on the sensed relative humidity.
The humidistat can be installed in the conditioned space that is being humidified, or within
the duct.
Input device used to communicate the relative humidity in a conditioned space or a duct to
the humidifier.
Input device used to limit the output of the humidifier by either shutting it down or throttling it
down when the humidity in the duct approaches the high limit.
Input device to ensure that humidification only occurs when air is moving through the duct.
Input device used to communicate the outdoor temperature to the humidistat so that it can
lower the setpoint value during cold weather to prevent condensation on exterior windows/
surfaces.
Application
Application
2582302_C_EN_1611 Nortec EL