Table of Contents
Advertisement
www.aeroplusrc.com
Rudder
1. Remove the covering where the rudder horns push through with either a hobby knife or soldering
iron.
2. Test fit the rudder horns
Note: Be sure the rudder horns are equal on both sides and in line with the hinge
point this is very important!
3. Sand the area on the horn that fits inside the rudder so the glue bonds better.
4. Attaching the rudder.
a. Insert the easy removal pin into the pin hinges.
AeroPlus RC Copyright 2014 © All Rights Reserved
service@aeroplusrc.com
Advertisement
Table of Contents
