Horizontal Stab - AeroPlus Extra 330LT Manual

www.aeroplusrc.com
 Tighten down the bolt holding the locknut.
Note – Do not over tighten. This will prevent the wheel from turning.
 Insert the protruding bolts through the landing gear hole.
 Tighten up using a washer and lock nut.
 Repeat for other side.
 This method takes time but is worth it as the wheel pants will last many flights.

Horizontal Stab

1. Now glue the control horns into the elevators.
a. First use a sharp hobby knife to remove the covering from the slots.
AeroPlus RC Copyright 2014 © All Rights Reserved
service@aeroplusrc.com