Table of Contents
Advertisement
www.aeroplusrc.com
5. Glue the rudder horns in the rudder with epoxy; wipe off excess glue while it is wet.
Note: Use the ball joint and bolt while gluing to maintain alignment.
Note: While still movable measure that the same amount pushes out each side. Care needs to be taken here
otherwise your rudder geometry will be incorrect.
6. Installing the Rudder Servo
a. If using the included ruder arm assemble the rudder servo control arm as below, drill holes for
screws and use C.A. glue to stop the nuts from coming loose.
b. Fit the rudder servo and drill holes using a 1/16 drill bit for the servo screws, then drop thin C.A.
glue into the holes to strengthen the wood.
Note: besure the glue has fully cured before installing the servo again.
AeroPlus RC Copyright 2014 © All Rights Reserved
service@aeroplusrc.com
Advertisement
Table of Contents
