Table of Contents
Advertisement
www.aeroplusrc.com
b. Before gluing the area on the horns that goes inside the elevator needs to be roughed up with
sandpaper. This allows a better glue joint.
c. Using Epoxy now glue the two control horns into their respective places.
Note: it is highly recommended to install a ball joint in between the control horns to maintain
proper spacing during gluing.
Note: also please take care to make sure the linkage whole in the control arm is on the hinge line.
2. Installing the elevator servos.
a. First test fit the servo into the servo mount. Some trimming make be required.
Note. Servo fits so spline is towards the front of the plane.
b. Now pre drill the servo mounts with a 1/16 drill bit, the secure the servo into the servo mount
with servo hardware.
AeroPlus RC Copyright 2014 © All Rights Reserved
service@aeroplusrc.com
Advertisement
Table of Contents
