www.aeroplusrc.com
service@aeroplusrc.com
b. Using sand paper rough the area that will be glued into the aileron.
c. Glue both horns in with epoxy glue.
Note: be sure to install a ball link to insure correct alignment when glueing
d. Repeat for all 4 aileron control horns.
3. Install Aileron Servos
a. First test fit the servo into the servo mount. Some trimming make be required.
Note. Servo fits so spline is towards the front of the plane.
AeroPlus RC Copyright 2014 © All Rights Reserved