Table of Contents
Advertisement
www.aeroplusrc.com
b. Connect the servo to the extension but be sure to use a servo clip or a piece of heat shrink to
4. Installing Elevator Halfs
a. Install the small carbon tube into the fuselage.
b. Slide the Elevator Half onto the tube.
Note: make sure the servo wire goes cleanly inside the fuselage and is not pinched.
c. Attached the elevator half to the fuselage with the provided hardware.
M3×12 inner hexagon screw & M3 wrench
5. Repeat the process for the other elevator half.
ensure it does not become disconnected during flight.
AeroPlus RC Copyright 2014 © All Rights Reserved
service@aeroplusrc.com
Advertisement
Table of Contents
