DeAGNOSTINI MODEL SPACE Red Bull Racing RB7 Manual page 30

Red Bull Racing RB7: Step by Step
14
Next, lay the side protector
on your work surface, with its
underside facing up, and apply glue
neatly to the edges marked with the
dotted green lines.
16
Next, lower the helmet (Stage 10)
into place on the raised section of
the cockpit, as shown by the red arrow.
15
With the front and middle body assembly positioned on your work surface as
shown, lower the side protector into place in the cockpit area, as shown. The three
pins on the underside of the side protector should sit inside the three holes in the middle
body's cockpit (indicated here by the red arrows).
17
Holding the parts in place, turn
the assembly around and insert
and tighten the 3 x 8mm dome-headed
screw into the hole in the underside of
the cockpit.
458
18
The next step is to attach the left
and right air intakes (Stage 87). To
do this, first test-fit the left air intake by
slotting it into place between the middle
and front body parts, as shown.
™