DeAGNOSTINI MODEL SPACE Red Bull Racing RB7 Manual page 13

Red Bull Racing RB7: Step by Step
06
Turn the lower nose and wing stay assembly over and line up the left front wing
stay with the side of the lower nose, as you did for the right stay in Step 02.
08
Lower the front left stay holder into
the recess in the stay so that the
holes line up, as indicated by the red arrow.
09
Secure the parts by tightening
the last of the 2 x 8mm flat-head
screws into the hole (arrowed).
441
07
Tighten the third 2 x 8mm
flat-head screw into the rear hole.
10
Your lower nose assembly should
now look like this. Make sure that
the screws holding the front wing stays
are fully tightened and that the stays
cannot wobble from side to side.
™