DeAGNOSTINI MODEL SPACE Red Bull Racing RB7 Manual page 12

Red Bull Racing RB7: Step by Step
01
For this session, you will need your model assembly and the parts supplied with this
stage. You will also need the upper nose (supplied with Stage 84), the lower nose
(Stage 17) and the front wing (assembled in Stage 03).
03
Insert and tighten the first of the
four 2 x 8mm flat-head screws
into the rear hole.
04
Next, position the right front
wing stay holder into the curved
recess on the stay.
440
02
Place the lower nose on its side
on your work surface, and line
up the right front wing stay as shown
above. The two holes on the stay's
straight edge should line up with those
on the lower nose, as shown by the two
red arrows.
05
With the stay holder in place,
insert and tighten the second 2 x
8mm flat-head screw to secure the parts.
™