Table of Contents
Advertisement
Red Bull Racing RB7: Step by Step
01
Before beginning, remove the
helmet air filter by pulling it
gently away from the engine's intake
port (red arrow).
04
Slot the straight end of the brake
rod into the indicated hole in
the servo horn.
02
Next, remove the servo horn by
undoing the screw at its centre.
05
Pull the rod through until the
angled section is resting against
the servo horn. Then use needle-nose
pliers to pull the bend through, so that
the section of the rod that is at a right
angle to the main part is inside the horn.
447
03
To ensure the servo horn doesn't
get caught up during operation,
use cutters to remove its shortest arm.
Make sure that you cut a neat, straight
line to follow the existing edge of the
servo horn.
06
Your assembly should look like
this, with the brake rod hooked
neatly into the servo horn.
™
Hide quick links:
Advertisement
Table of Contents
