DeAGNOSTINI MODEL SPACE Red Bull Racing RB7 Manual page 20

Red Bull Racing RB7: Step by Step
07
Holding the servo horn and
brake rod assembly as shown,
feed the rod's free end through the
eye of the brake lever attached to your
model's rear differential housing.
10
If you find tightening the ball
end difficult, wrap the base of
the rod in cloth to prevent any damage,
then grip it with needle-nose pliers for a
firmer hold.
08
When your assembly looks like
the one in the photo, line up the
servo horn and re-insert and tighten the
screw removed in Step 02.
11
Your assembly should look like
this, with the threaded tip of the
rod fully concealed within the ball end.
448
09
Next, tighten the ball end onto
the threaded tip of the throttle
linkage rod.
12
The throttle linkage rod will be
attached to the free side of the
servo horn. Place the 2mm washer over
the circled hole.
™