Red Bull Racing RB7: Step by Step
15
Tighten the screw with a
screwdriver.
18
Lay your front wing and lower nose assembly on your work surface, as shown, and
double-check that all the parts are attached correctly and securely, with no gaps.
16
Check that the pin on the other
stay is still in position, then insert
the other 1.4 x 8mm flat-head screw into
the arrowed hole.
443
17
Tighten with a screwdriver, then
check both screws to make sure
that they are holding securely.
19
Take the nose camera supplied
with this stage and slot it into
place on the front end of the lower nose,
as shown in the photo.
™