DeAGNOSTINI MODEL SPACE Red Bull Racing RB7 Manual page 14

Red Bull Racing RB7: Step by Step
11
Place the front wing assembled in Stage 03 flat on your work surface, and position
the lower nose assembly directly above its centre so that the two wing stays line up
with the raised sections indicated by the red arrows.
13
Your assembly should now look
like this. Make sure that there are
no gaps at the join between the front
wing stays and the wing.
14
Holding the assembly together, carefully turn it over so the underside of the front
wing is facing upwards. Then insert the first of the 1.4 x 8mm flat-head screws into
the arrowed hole.
442
12
Fit the lower nose onto the front
wing assembly. The bottom
end of each wing stay has a small pin
towards the rear edge, which fits into a
corresponding hole in the front wing, as
indicated by the red arrow.
™