DeAGNOSTINI MODEL SPACE Red Bull Racing RB7 Manual page 29

Red Bull Racing RB7: Step by Step
10
Place the middle body flat on your work surface, and carefully apply glue to the
edge marked with the dotted green line. Be very careful not to let the glue spill over
onto the sides of the part.
12
Lay the front body and nose assembly, glued together in Step 09, on your work
surface with the underside facing up. Then, with the middle body also with its
underside facing up, lower the part into place. The round hole at the very tip of the
middle body should sit around the small pin at the centre of the front body's underside
(see red arrow).
457
11
Immediately, before the glue
applied in Step 10 has dried,
apply more adhesive to the areas at the
tip of the middle body marked here with
the dotted green lines.
13
The front and middle body
should meet neatly along their
shared edges, with the pin sitting neatly
within the hole at the tip of the middle
body, as shown.
™