The Throttle And Brake Rods - DeAGNOSTINI MODEL SPACE Red Bull Racing RB7 Manual

Red Bull Racing RB7: Step by Step
25
When the plastic brake collar is in
position, slide the second 10mm
length of silicone tubing onto the brake
rod (see red arrow).
28
Slide the stopper over the free end
of the brake rod so that it rests
against the silicone tube, but with no
pressure on any of the brake components,
then tighten the set screw fully to secure
the parts.
26
Prepare the other set screw as
you did the first one, by placing
it on an Allen key and dabbing it with
thread-locking compound.
29
This stage is now complete. Your assembly should look like this, with the throttle and
brake rods secured and sitting roughly parallel to each other when the servo horn is
straight. Store your assembly away safely until next time.
451
27
Insert the screw into the second
2mm stopper, and tighten it by
only a few turns.
™