DeAGNOSTINI MODEL SPACE Red Bull Racing RB7 Manual page 21

Red Bull Racing RB7: Step by Step
13
Now lay the throttle linkage on
your work surface and insert the
first 2 x 8mm flat-head screw supplied
with this stage into the arrowed hole.
16
Slide the throttle spring over the
free end of the throttle linkage
rod and along so that it rests against the
ball end.
14
Holding the part with needle-
nose pliers, lower the projecting
screw tip into the hole of the servo horn,
making sure it runs through the 2mm
washer first.
17
With the spring in position, insert
the free end into the arrowed
hole in the linkage base. Keep feeding
the rod through until the spring rests
against the side of the linkage base.
449
15
Turn the screw to secure the
parts, but don't screw it in too
tightly. Leave it just loose enough for the
throttle linkage base to be able to swivel
easily from side to side.
18
Rotate the linkage base and rod
so that the rod's ball end lines up
with the throttle lever on the carburettor
(red arrow). Then push the ball end onto
the throttle lever until it snaps into place.
™