DeAGNOSTINI MODEL SPACE Red Bull Racing RB7 Manual page 28

Red Bull Racing RB7: Step by Step
05
To begin the assembly work, remove the two yellow nose parts from the front wing,
as shown. Remember, if you are planning to paint your RB7's display body, the parts
should be painted before assembly (see Step 01).
07
Very carefully apply some glue
along the front of the front wing,
as shown by the dotted green line.
08
Set the yellow nose assembly
built in Step 06 onto the front
wing, where the glue was applied in Step
07. Press down to secure the parts and
leave to dry fully before proceeding.
456
06
Place the parts on your work
surface facing up, then dab the
sections indicated by the dotted green
lines with modelling adhesive. Then
press the parts together, as was done
for the test-fit, and set aside to allow the
glue to dry.
09
Apply some glue to the front
edge of the front body, marked
here with a dotted green line, then press
the lower nose up against it as indicated
by the red arrow. Let the glue dry fully.
™