Panasonic S-36PU1E5 Technical Data & Service Manual page 181

Pattern 2 f I h t e e r s i a n o
above the discharge.)
• If the upper part is open
• If there are obstacles above the unit
For separate installation location
• The dimensions for H, A and L are shown in the following
table.
L H
H < L Install a pedestal or mount so that L H
• Cover the bottom part of the pedestal or mount so that air
does not go through it.
2 For multiple units (up to 2 units)
• The dimensions for H, A and L are shown in the following table.
L H
H < L Install a pedestal or mount so that L
• Cover the bottom part of the pedestal or mount so that air
does not bypass it.
• A limit of only 2 units can be installed.
(D) Stacking installation setup
• Stack up to 2 tiers.
• A dimension of approximately 400 mm is required for the second tier outdoor unit's drain pipe and space for maintenance of
the fi rst tier outdoor unit.
• Close A section (the space between the upper and lower level outdoor units) so the outtake air does not bypass it.
1 If there are obstacles at the discharge
A section
(E) For multiple row installation (on the roof, etc.)
1 For one row installation setup
• The above mentioned distance is required for optimal unit performance.
Allow as much space as possible in order to obtain the best performance from the units.
TRANSPORT AND INSTALL THE OUTDOOR UNIT
Transporting
1. Transport the outdoor unit in its original packaging as close as possible to the installation location.
2. In the event that the unit needs to be lifted or suspended, use a rope or belt and use cloth or wood as padding to avoid damaging
the unit.
3. Use the side handles to carry the unit and be careful not to touch the fan with your hand or
any objects.
Installation
1. Read the "Select the outdoor unit installation location" thoroughly before installing the outdoor
unit.
2. When installing to a concrete or solid surface, use M10 or a W 3/8 bolts and nuts to secure
the unit. Ensure that it installed upright on a horizontal plane. (Use an anchor bolt for the
installation as shown in the diagram below.)
3. Avoid installing on the slanted roof.
4. In the even where the roof is at risk of receiving oscillations
or vibrations, secure the unit with a seismic isolating mount or
vibration absorbing rubber.
5. The drain water will be discharged from the unit during heating
or defrosting operation mode.
Select an appropriate location with good drainage system. (In the winter,
there is risk of slipping due to freezing, and depending on the installation
set up there is risk of drain water running overhead.)
Please consult us if installing drain elbows.
In cold regions (where the outdoor temperature can drop to below 0˚
for 2 to 3 consecutive days), the drain water may freeze and may
prevent the fan from operating. For this case, do not use the drain
elbow.
b s a t c e l h t t a s i h g i h r e h t a n h t e
For separate installation location
A
1 0 0
A
2 0 0
H
• The dimensions for H, A and L are shown
in the following table.
L H
H < L Installation not possible
u n t i o n h t e i d c s h a g r e s d i . e T ( h
2 If there are obstacles at the intake
A section
2 For multiple units (more than 2 units)
A
200
220
170
1-175
e e r s i n o i l m t i o t h t e h e g i t h f o h t
2 For multiple units (more than 2 units)
Anchor bolt length
(Unit: mm)
200 160 321
620 150
(Anchor pitch)
Anchor bolt position
1
e o b s a t c e l