Table 6.2 Service tasks
Clip removal and attachment (garment clip shown)
Lift the clip's cover.
To attach the clip cover,
place the screw through the
center hole of the clip back.
Instrument assembly
Hold the case bottom near
the upper screw holes.
Use a Philips screwdriver to
access the clip's screw. Turn
counterclockwise to loosen
and remove the screw and
washer.
Guide the screwdriver
through the clip's hole and
into the screw head. Turn
clockwise to tighten.
Note: Refer to Table 6.1 for torque
values.
Lower the case top assembly
onto the case bottom. Use a
straight-down motion to
guide the sensors into the
sensor barrels.
Lift the clip to remove it.
Close the clip; store it for
future use.
Press to secure the case top
and case bottom.
45
Using a torx screwdriver,
insert and tighten each of the
four screws into the case
bottom.
Note: Refer to Table 6.1 for torque
values.