ProForm PFTL39305.0 User Manual page 8

5. Loosen the two Crossbar Screws (98) (only one is shown)
several turns. Place the Console Base (87) on the Right
Handrail (16) and the Left Handrail (not shown). Make
sure that the Wire Harness (53) is not pinched by the
Right Handrail. Attach the Console Base with four 3/4"
Screws (5) (only two Screws are shown). Start all four
Screws before tightening any of them.
Insert the Wire Harness (53) through the two indicated
plastic ties on the Console Base (87). Next, insert the
Wire Harness up through the opening beside the Wire
Cover (10). Make sure that the Wire Cover is securely at-
tached to the Console Base.
See the inset drawing. Look at the top of the Console
Base (87). Insert the Wire Harness (53) through the plas-
tic tie on top of the Console Base.
6. Hold the Console (10) near the Console Base (87).
Touch the Right Handrail (16) to discharge any static.
See the inset drawing. Find the 2-wire connector on the
end of the Wire Harness (53). Insert the connector into
the red socket beneath the Console. The connector
should slide in easily and snap into place. If it does
not, turn the connector and then insert it. Insert the 6-
wire connector into the other socket beneath the Console
the same way.
Insert the excess Wire Harness (53) down through the
opening in the Console Base (87) (see the inset drawing
in step 5). Securely tighten the plastic tie on top of
the Console Base to prevent the Wire Harness from
slipping. Then, cut off the end of the plastic tie.
Make sure that the connectors and wires appear as
shown at the right. IF THE CONNECTORS ARE NOT
INSERTED PROPERLY, THE CONSOLE MAY BE
DAMAGED WHEN THE POWER IS TURNED ON.
See drawing 6a. Press the Bookrack (85) onto the Console
Base (87) in the location shown.
Set the Console (10) on the Console Base (87). Insert
the excess Wire Harness (53) into the large hole in the
side of the Right Handrail (16). Securely tighten the
plastic ties on the bottom of the Console Base to
prevent the Wire Harness from slipping. Then, cut off
the ends of the plastic ties.
Attach the Console (10) to the Console Base (87) with two
3/4" Screws (5) and four 1/2" Screws (97). Start all six
Screws before tightening any of them; do not over-
tighten the Screws. Tighten the two Crossbar Screws
(98) (only one is shown).
5
87
Ties
16
98
5
6
Ties
98
16
6a
87
8
53
10
53
53
10
97
5
5
97
53
2-wire
85
Tie
87
87
97
6-wire