HP 9000 Installation Manual page 8

D Class Internal Peripherals Installation
Internal Peripherals Installation Overview
After completing the installation procedures, proceed to the Peripherals
Installation Verification section (located after the installation
procedures) for instructions on how to verify that internal peripherals
have been correctly installed.
Required Tools • Small flat-bladed screwdriver
• Torx driver, #15
• Torx driver, #10
• Phillips screwdriver
Safety Considerations
Turn off the system power and disconnect the power cable before
WARNING
opening the system cabinet. Otherwise, personal injury may
occur.
Electrostatic discharge can damage the integrated circuits on printed-
Electrostatic
Discharge Precautions
circuit boards. To prevent such damage from occurring, be sure to
observe the following precautions when handling and installing boards:
• Use a grounding mat and an anti-static wrist strap, such as those
• Wear the anti-static wrist strap to ensure that any accumulated
• Keep uninstalled printed-circuit boards in their protective anti-static
• Handle printed-circuit boards by their edges after you have removed
1-2
included in the ESD Field Service Kit (HP P/N A3024-80004).
electrostatic charge is discharged from you body to ground.
bags until you are ready to install them.
them from their protective anti-static bags.
Chapter 1