HP 9000 Installation Manual page 22

D Class Internal Peripherals Installation
Installation Procedures
3. Insert the removable media devices and bracket, then insert the hot-
4. Connect the "hot-swap detect" cable and hot-swap blower fan power
NOTE The Fast/Wide SCSI ribbon cable for the hot-swap disk bay is connected
as part of the procedure for installing the EMI cover (refer to step L).
Refer to step A at the beginning of this guide for procedures on installing
the Fast/Wide SCSI disks.
1-16
swap disk bay directly under the removable media devices. Secure the
bracket with four (4) screws (2 per side), and the hot-swap bay with
six (6) screws (3 per side).
cable to the system board, then connect the disk bay power cable from
the power supply to the power connector on the backplane of the disk
bay.
Chapter 1