HP 9000 Installation Manual page 40

R Class Internal Peripherals Installation
Installation Procedures
I. Install
The removable media slot can contain a CD-ROM drive or a DDS tape drive. Refer
Removeable Media
to the illustration on page 2-11 while performing this procedure.
Drives
NOTE
If devices are already installed in the removeable media bracket, you must
disconnect all data and power cables from the devices before performing the
following procedure.
1. Disconnect the P6 power cable (callout 1) from the rear of the removeable media
2. Remove the screw from bracket at the rear of the removeable media bay (see
3. Remove the two screws attaching the removeable media bay to the front of the
4. Attach the P6 power cord segment to the new device.
5. Pull the ribbon cable through the empty bay and attach it to the new removeable
6. Insert the removable media drive mechanisms into the removable media bracket,
7. Slide the bay back into the chassis, and secure it with the two screws removed in
8. Reconnect the P6 power cable (callout 1).
2-10
bay.
callout 2). Pull the bracket back and out.
chassis. Pull the removeable media bay forward.
media device.
and secure the drives to the bracket with eight (8) screws (four each, top and
bottom). (See callout 3 in the illustration.)
step 3.