HP 9000 Installation Manual page 43

D class and r class internal peripherals enterprise servers

Hide thumbs Also See for 9000:

K. Replace the

1. Verify that an anti-static strap is still strapped to your wrist, and grounded to the

Processor/

Memory Card

2. Place the Processor/Memory card into the system cabinet so that the card rests in

3. Pull the extractor levers on the Processor/Memory card out away from the card.

4. Slide the Processor/Memory card into the system cabinet until the large

5. Push in the two extractor levers on the Processor/Memory card.

6. Insert and tighten two screws to secure the Processor/Memory card in the

7. Reattach power cables P13 and P14.

cabinet main chassis.

the metal rails with the large connector facing into the cabinet (see the figure on

page 2-8).

connector is properly seated in the corresponding system board connector.

cabinet.

R Class Internal Peripherals Installation

Installation Procedures

2- 13

Table of Contents